sungo.io

About - RSS - Code

Duet Smart Effector Fan Support

A remix of the support for a part fan duct so it’ll work with my new hotend. This one is a bit more custom but maybe it’ll give someone the starting point I lacked.

I have a Mosquito hotend mounted on to a Duet Smart Effector with a mount from 713maker.com Somehow, there are no part fans for a Mosquito + Duet Effector that came even close to actually working for for me. Eventually though I settled on a 180 degree fan duct for 40x10mm fan. Problem was that the fan wasn’t low enough or even close to centered.

After much prototyping, I arrived at this part. The support gets the duct around 1mm above the print zone and centers it around the nozzle. The photos show it printed in some 3D Solutech I had lying around. Final version, like the fan duct, is in Prusament Natural PC Blend.

The fan is a MakerHawk 40x10 24V brushless via Amazon.

Built in Tinkercad

(License is maintained from the original model.)

Remixed From:

Download

License

This license supercedes the general site-wide license.

This content is copyright © sungo (https://sungo.io) and licensed under the following terms.

Creative Commons Attribution-ShareAlike: This license allows reusers to distribute, remix, adapt, and build upon the material in any medium or format, so long as attribution is given to the creator. The license allows for commercial use. If you remix, adapt, or build upon the material, you must license the modified material under identical terms.

STLs

Images