sungo.io

About - RSS - Code

Fume Extractor

Due to some physical constraints, I sometimes solder at different heights. None of the fume extractor models fit the bill so I hacked these two together to put a Noctua 140mm fan plus charcoal filter on a microphone boom. Let’s me adjust the fan location and frees up valuable table space when it’s not in use.

The fan is held in place by 30mm M4 screws with nuts.

Built in Tinkercad

Remixed From:

Download

License

This license supercedes the general site-wide license.

This content is copyright © sungo (https://sungo.io) and licensed under the following terms.

Creative Commons Attribution: This license allows reusers to distribute, remix, adapt, and build upon the material in any medium or format, so long as attribution is given to the creator. The license allows for commercial use.

STLs

Images