About - RSS - Code

TLM Floating Extruder Bracket With Filament Guide

I’m short so I mounted my Tevo Little Monster’s spool holder on the left upright. This causes some strain on the filament as it enters the extruder, particularly near the top. I made this simple remix to add a filament guide that moves the strain point above the extruder.

The hole is big enough for 2mm PTFE if one wanted to protect the filament further. That turned out to be unnecessary for me.

Made in Tinkercad:

The print in the photo was printed with ProtoPasta Matte Fiber White PLA

Remixed From:




This license supercedes the general site-wide license.

This content is copyright © sungo ( and licensed under the following terms.

Creative Commons Attribution: This license allows reusers to distribute, remix, adapt, and build upon the material in any medium or format, so long as attribution is given to the creator. The license allows for commercial use.