About - RSS - Code

TLM Wire Guide

This wire guide bolts into the underside of the Tevo Little Monster top plate. It helps guide the wire bundle in the right direction and keeps it from creeping back up the center hole. It should also help prevent the wire bundle from getting tangled in the top of the carriages.

The piercing in the middle is to allow for a zip tie so the cable can be held as securely as you’d like.

Compared to the original, I removed the bracket that fit up into the center hole because I paired it up with a grommet by bLITzJon and bolted them together. Might need a washer or two in between this part and the plate for the best fit. I used a couple nylon washers I had laying around.

Built in Tinkercad

Remixed From:




This license supercedes the general site-wide license.

This content is copyright © sungo ( and licensed under the following terms.

Creative Commons Attribution-ShareAlike: This license allows reusers to distribute, remix, adapt, and build upon the material in any medium or format, so long as attribution is given to the creator. The license allows for commercial use. If you remix, adapt, or build upon the material, you must license the modified material under identical terms.